Concrete services / Geelong, VIC
Geelong Equipment Pads
Provide a concrete mounting area for outdoor equipment, coordinated with installer drawings and maintenance access.
Your project starts here
Equipment Pads in Geelong
Provide a concrete mounting area for outdoor equipment, coordinated with installer drawings and maintenance access.
Different units transfer their loads through different feet, rails or mounting frames. Start with the equipment model and the installer’s support detail.
Send your Geelong suburb, photographs and any relevant drawings with your enquiry so the proposed work can be reviewed against the actual site.
For Geelong Equipment Pads, explore our homepage to see how your project connects with our wider range of concrete services, then share the site details that matter for your property.
Equipment Pads / Project guide
Identify the equipment and its support points
Different units transfer their loads through different feet, rails or mounting frames. Start with the equipment model and the installer’s support detail.
Provide dimensions and any mounting template. The concrete scope can then be discussed against the actual equipment instead of a rough external footprint.
Equipment Pads / Project guide
Plan the location around servicing
Access to panels, filters and connections can determine where an equipment pad belongs. A tucked-away location may be inconvenient once the unit is operating.
Ask the installer to identify the required clearances. Include the route a technician would use to reach the equipment with tools.
Equipment Pads / Project guide
Coordinate fixings and embedded items
Anchors and penetrations need to suit the equipment and the concrete design. Their positions should not be improvised after the pad has been poured.
Share the fixing information before construction. Clarify whether cast-in items, later drilling or installer-supplied components form part of the agreed scope.
Equipment Pads / Project guide
Work within a confined service corridor
Many small pads are installed between a wall and a fence, where delivery and preparation access are limited. Existing pipes and paving can further restrict the work.
Send photographs looking along the whole corridor. Include gate widths and note whether existing equipment needs removal by another trade.
Equipment Pads / Project guide
Hand over to the installer with clear timing
A completed concrete pad is not automatically ready for every installation load. Equipment delivery and fixing work need an agreed return-to-use sequence.
Confirm the handover details with the installer and concrete team. Keep the mounting information available for future equipment replacement.
Useful to know
Frequently Asked
Questions
Can you make a pad for an air conditioner?
Send the unit model, installer support requirements and location photos so the pad scope can be assessed.
Do you install the equipment?
Equipment placement and commissioning are separate unless explicitly included with the relevant installer.
Can an old pad be reused?
Reuse depends on its dimensions, condition and compatibility with the new equipment requirements.
How high should an equipment pad sit?
Height depends on the installer’s requirements, drainage and the surrounding surfaces. Pads for plant such as heat pumps or air conditioners usually need to sit clear of pooling water.
Do equipment pads need reinforcement?
That depends on the pad size, the equipment’s operating weight, fixings and ground conditions. Provide the installer’s drawings so an appropriate specification can be established.
Let’s make it concrete
Let’s plan your equipment pads.
Share your suburb, approximate dimensions and the existing surface. We’ll start with the details that matter.